Pioneer CNDV-50MT - Manual (Page 71)

69
A
ppe
n
d
ix
Setting of the Installation direction
lever is wrong.
Check the installation position of the
navigation unit of your Navigation
System and the setting of the
Installation direction lever ( ➞
“Installation Manual”).
Indication of the position of your
vehicle is misaligned after a U-turn or
reversing.
Check whether or not the reverse
gear signal input lead (purple) is
connected properly. (The Navigation
System works properly without the
lead connected, but positioning
accuracy will be adversely affected.)
The map continually reorients itself. The travelling direction is always set
to north.
Touch on the screen and change
the map display.
Tracking marks are not displayed. The “Tracking Display” is turned
off.
Check the “Tracking Display”
settings ( ➞ Page 50) and make sure
“Always” or “This Trip” is selected.
The daylight display is used even
when the vehicle lights are on.
Daytime is selected on “Day/Night
Display”.
Check the “Day/Night Display”
setting ( ➞ Page 50) and make sure
“Illuminated” is selected.
The Orange/white lead is not
connected.
Check the connection.
The system will not switch on or will
not operate.
Installation or connection has been
carried out incorrectly.
Check with your dealer.
The display is very dim. The vehicle’s light is turned ON, and
“Illuminated” is selected on “Day/
Night Display”.
Read about the “Day/Night
Display” setting ( ➞ Page 50) and, if
desired, select “Daytime”.
The vehicle cabin temperature is
extremely low.
A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the
vehicle to warm up.
There is no voice guidance or the
volume is low.
The volume setting is low or the
speaker lead is disconnected.
Check the volume setting on the
display or turn the volume up
according to “Hardware Volume”
( ➞ Page 50) and/or turn up the
volume on the display.
The remote control fails to work. Uses a type of remote control that
cannot be used with a touch panel
system.
This navigation system mainly uses
touch panel operation. If you use a
remote control, only some of the
system’s buttons can be used.
The batteries are low. Change the batteries.
The batteries have been inserted
incorrectly.
Check that the batteries are properly
inserted according to the + and –
markings.
The remote control is pointing at the
floor or a seat.
Ensure that the remote control has a
clear line of sight to the display unit.
The signal receptor on the display is
exposed to direct sunlight.
Move the remote control closer to the
receiver on the display unit.
When the screen is frozen...
Park your vehicle at a safe place, and cut the engine off. Turn the ignition key back to “Acc off”. Then
start the engine again, and turn the power to the main unit back on. If this does not solve the
problem, press the Reset button on the main unit.
Symptom Cause Action (See)
MAN-CNDV-50MTP-EN.book Page 69 Friday, April 29, 2005 10:33 AM