Pioneer CNDV-50MT - Manual (Page 55)

53
Ch
ap
te
r
5
Ope
rat
in
g Y
o
u
r N
aviga
tio
n
S
yst
em
w
ith
Vo
ic
e
Chapter 5
Operating Your Navigation System with Voice
Basics of Voice Operation
To Ensure Safe Driving
• For safety reasons, Voice Help menu
(Voice Recog.Help) is not available while
your vehicle is in motion. To enable this
function, you must stop in a safe place and
put on the handbrake before setting your
route.
Your Pioneer Navigation System comes with the
latest in voice recognition technology. You can
use voice commands to operate many of its
functions. This chapter describes where you can
use voice commands, and also what commands
the system accepts.
Flow of voice operation
You can start voice operation any time even when
the map screen is displayed or audio is operated.
The basic steps of voice operation are as follows.
The steps are almost the same as when using the
Remote Control.
❒ With the “CD-SR80” Steering Remote Control
(sold separately), you can press the BAND
button and the F button to switch on the
operation mode of the Steering Remote
Control. When the operation mode is
switched on, by pressing the BAND button of
the Steering Remote Control, you can activate
voice operation, which is equivalent of
pressing the TALK (or VOICE) button. (“CD-
SR90” and “CD-SR100” can be used. For the
details of their operation, see the instruction
manuals attached to them.)
When using voice operation for the first
time
Until you are familiar with this system, it is
recommended to stop the vehicle in a safe place
and refer to the commands displayed in the Voice
Help menu (a list of the words you can speak).
When your vehicle is parked with the handbrake
on, press the TALK (or VOICE) button or touch
VOICE icon to display a list of available voice
commands (Voice Help menu). Display of the
Voice Help menu can be turned on/off with
“Voice Recog.Help” in the Settings menu.
1
Press the TALK (or VOICE) button or
touch VOICE icon to activate voice
operation.
2
Speak a command into the
microphone.
3
When the command is recognised, it is
repeated.
4
As necessary, repeat Steps 2 and 3.
5
The voice command is carried out.
MAN-CNDV-50MTP-EN.book Page 53 Friday, April 29, 2005 10:33 AM