Pioneer CNDV-50MT - Manual (Page 73)

71
A
ppe
n
d
ix
Route calculation was not possible. Route calculation has failed because
of malfunction of map data, software,
hardware, or disc.
• Change the destination.
• Clean the disc.
• Consult the Pioneer Local dealer if
this message persists.
Route calculation was not possible
because the destination is too far.
The destination is too far. • Set a destination closer to the
starting point.
• Set one or more way points.
Route calculation was not possible
because the destination is too near.
The destination or way point(s) is too
close.
Set a destination [and way point(s)]
farther from the starting point.
Route calculation was not possible
due to traffic regulations.
• The destination or way point(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a
Control Traffic Zone (CTR) and the
route calculation is hampered.
• Set a destination and way point(s)
outside the CTR if you know where
the restricted area is.
• Try the destination or way point(s)
away from the currently set points to
some extent.
• Drive your vehicle to an
unrestricted area and reset the
destination and way point(s).
Route calculation was not possible
because no guidance can be
provided around the destination or
the starting point.
The destination, way point(s), or
starting point are in an area where no
road exists (e.g. a mountain) and the
route calculation is impossible.
• Set a destination and way point(s)
on roads.
• Reset the destination after you
drive the vehicle to any road.
There is no route to the destination. The destination or way point(s) are in
an isolated island, etc. without a ferry
and the route calculation is
impossible.
Change the destination.
Your journey can not avoid the
specified area.
If route setting cannot avoid
specified Areas to Avoid.
If the current route is not desired, set
destination or way points that do not
pass through the Areas to Avoid.
The route could not avoid the
specified area.
Toll road has not been avoided.
If the route to the destination (or way
point) cannot be established by
bypassing toll roads (including toll
areas) and Areas to Avoid.
If the current route is not desired, set
destination or way points that do not
pass through toll roads (including
toll areas) and Areas to Avoid.
Ferry has not been avoided. In case a ferry route was included in
the route to the destination or way
points even though “Avoid Ferry”
was set to “On”.
If the current route is not desired, set
destination or way points that do not
pass through a ferry route.
Toll road has not been avoided. If the route to the destination (or way
point) cannot be established by
bypassing toll roads (including toll
areas).
If the current route is not desired, set
destination or way points that do not
pass through toll roads (including
toll areas).
There is no applicable data for the
selected city. Automatically returning
to list.
If the history data of the City could
not be used (for example, in case that
the history data of the City that was
used in the POI Search cannot be
found in the Address Search.)
Once the search is performed to
specify the City, the result is saved as
a history. The data of the specified
City, however, may not be hit by the
different search criteria. In this case,
try another search method or change
the destination.
There is no Mortorway in this area. If no motorway was found in the
selected country.
Set the destination or way points
using another search method or
change the location of the
destination or way points.
This area does not contain any POI’s
of the selected type.
Facilities of the selected category do
not exist in the surrounding areas.
Use another search method or move
to another location and perform the
POI search again.
The maximum number of
registrations has been completed.
Please clear existing registered items
and re-register current item.
If there are already 300 items when
you attempt to register an item in the
Address Book.
Delete unnecessary data and try to
register again.
Message When What to do
MAN-CNDV-50MTP-EN.book Page 71 Friday, April 29, 2005 10:33 AM