Pioneer CNDV-50MT - Manual (Page 50)

48
Ch
ap
te
r
3
E
d
it
in
g t
h
e Na
viga
ti
o
n
Ut
il
it
ie
s
To clear values...
If you want to delete the learned results stored in
“Distance”, “Speed Pulse” or “Learning
Status”, touch each item, then touch “Clear”.
❒ The navigation system can automatically
detect outer dimensions of the tyres. If tyres
have been replaced, the navigation system
automatically detects it and begins learning
according to the new tyres.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation unit and the vehicle. Please also
check whether they are connected in the correct
positions.
1
Touch “Information” in the Main menu,
then touch “Connection Status”.
The Connection Status screen appears. The
reception status of the signal and the
connection status of each cable are shown.
1. Speed Pulse
The Speed Pulse value detected by the
navigation system is shown. “0” is shown
while the vehicle is stationary.
2. GPS Aerial
Indicates the connection status of the GPS
aerial, the reception sensitivity, and from
how many satellites the signal is received.
The sign of “OK” is displayed when the
signal is received normally. The sign of “No
good” is displayed when the reception
condition is not good.
3. Installation Position
Indicates whether the Installation position
of the navigation unit is correct or not.
When the navigation unit is installed with
an extreme angle exceeding the limitation
of the installing angle, “Incorrect angle”
will be displayed. When the angle of the
navigation unit has been changed,
“Excessive vibration” will be displayed.
4. Hand brake
When the handbrake is applied, “On” is
displayed. When the handbrake is released,
“Off” is displayed.
5. Power Voltage
The power supply (reference value)
provided from the vehicle battery to the
navigation system is shown. If the voltage
does not fall within the range of 11 to 15V,
check that power cable connection is
correct.
6. Illumination
When the headlights or small lamps of a
vehicle are on, “On” is displayed. (If the
orange/white lead is not connected, “Off”
appears.)
7. Back Signal
When the gear lever is shifted to “R”, the
signal switches to “High” or “Low”. (Which
of these is displayed depends on the
vehicle.)
1
2
3
4
5
6
7
MAN-CNDV-50MTP-EN.book Page 48 Friday, April 29, 2005 10:33 AM