Pioneer CNDV-50MT - Manual (Page 70)

68
App
en
d
ix
Troubleshooting
If you have problems operating your Navigation System, refer to this section. The most common
problems are listed below, along with likely causes and solutions. While this list is not comprehensive,
it should answer your most common problems. If a solution to your problem cannot be found here,
contact your dealer or the nearest authorised Pioneer service facility.
Problems in the navigation screen
Symptom Cause Action (See)
Power doesn’t turn on.
The unit doesn’t operate.
Leads and connectors are incorrectly
connected.
Confirm once more that all
connections are correct.
The fuse is blown. Rectify the reason for the fuse
blowing, then replace the fuse. Be
very sure to install the correct fuse
with the same rate.
You cannot position your vehicle on
the map or the positioning error is
large.
The quality of signals from the GPS
satellites is poor, causing reduced
positioning accuracy. Such a loss of
signal quality may happen for the
following reasons:
• The GPS aerial is in an unsuitable
location.
• Obstacles are blocking signals
from the satellites.
• The position of satellites relative to
your vehicle is bad.
• Signals from the GPS satellites
have been modified to reduce
accuracy. (GPS satellites are
operated by the US Department of
Defense, and the US government
reserves the right to distort
positioning data for military reasons.
This may lead to greater positioning
errors.)
• If a vehicle phone or cellular phone
is used near the GPS aerial, GPS
reception may be lost temporarily.
• Do not cover the GPS aerial with
spray paint or vehicle wax, because
this may block the reception of GPS
signals. Snow buildup can also
degrade the signals.
Check the GPS signal reception ( ➞
Page 48) and the position of the GPS
aerial if necessary, or continue
driving until reception improves.
Keep the aerial clear.
Signals from the vehicle’s speed
pulse are not being picked up
properly.
Check that the cables are properly
connected. If necessary, consult the
dealer that installed the system.
The navigation unit may not be
mounted securely in your vehicle.
Check that the navigation unit is
securely mounted and, if necessary,
consult the dealer that installed the
system.
Your vehicle is operating in Simple
hybrid mode.
Connect the speed signal input (pink
lead wire) of the power cable
correctly, and clear the 3D Hybrid
Sensor memory (“Learning
Status”).
The navigation unit is installed with
an extreme angle exceeding the
limitation of the installation angle.
Confirm the installation angle. (The
navigation system must be installed
within +30 degrees to –15 degrees of
the horizontal, or within five degrees
of your vehicle’s direction of travel.)
MAN-CNDV-50MTP-EN.book Page 68 Friday, April 29, 2005 10:33 AM