Barco R9001960 - Manual (Page 41)

5. Start Up mode
5. START UP MODE
What can be done?
1. During start up, the projector can show first the identification screen or a blank screen.
2. The projector can start up with auto power. The projector starts up in the same power condition as it was before power supply
was interrupted.
5.1 Start up with identification screen
How to set up?
1. Push the cursor key ↑ or ↓ to highlight Start Up Mode. (menu 8-18)
2. Press ENTER to display the start up mode menu. (menu 8-19)
3. Push the cursor key ↑ or ↓ to highlight Identification.
4. Press ENTER to toggle between [ON] or [OFF].
[ON] projector identification will be displayed during start up.
[OFF] a blank screen will be displayed during start up
INSTALLATION
INPUT SLOTS
NO SIGNAL
LENS
TEXT BOX POSITION
QUICK ACCESS KEYS
START UP MODE
NETWORK CONFIGURATION
more ...
Select with ↑ or ↓
then
to return.
Menu 5-1
START UP MODE
IDENTIFICATION : [ON]
AUTO POWER : [ON]
Select with ↑ or ↓
then
to return.
Menu 5-2
5.2 Start up auto power
Set up the auto power mode.
1. Push the cursor key
↑
or
↓
to highlight Start Up Mode. (menu 8-20)
2. Press ENTER to display the start up mode menu. (menu 8-21)
3. Push the cursor key
↑
or
↓
to highlight Auto Power.
4. Press ENTER to toggle between [ON] or [OFF].
[ON] projector starts up as it was switched off before. When the projector was in standby before it was switched
off, it starts up in standby. When it was switched off with full power, it starts up with full power.
[OFF] projector always starts up in standby mode.
INSTALLATION
INPUT SLOTS
NO SIGNAL
LENS
TEXT BOX POSITION
QUICK ACCESS KEYS
START UP MODE
NETWORK CONFIGURATION
more ...
Select with ↑ or ↓
then
to return.
Menu 5-3
START UP MODE
IDENTIFICATION : [ON]
AUTO POWER : [ON]
Select with ↑ or ↓
then
to return.
Menu 5-4
R5976182 BARCOREALITY 6500 30012001 37