Xerox DocuColor 240-250 con built-in Fiery controller-16150 - Manual (Page 22)

Page 22
Date and time stamps for jobs
You can print the following reports:
• Job Status
• Scan Mode Settings
• Copy Mode Settings
• Network Controller Jobs Report
All jobs in Job Status, Scan Mode Settings, and Copy Mode Settings use the date and time
on the copier.
You can print the following reports from Network Controller Jobs Report:
• Job History Report
• Error History Report
• Fonts List
• System Settings List
The Job History Report, Fonts List, and System Settings List use the date and time on the
Fiery. The Error History Report uses the date and time on the copier (except for error codes
from the Fiery).
Job batching
If job batching is enabled, multiple jobs received by the Fiery close together are printed as a
single job. You can control job batching through the Job Batching Delay option under More
Setup in WebTools. If this option is set to 0, job batching is disabled. If this option is set to a
nonzero value, jobs that are received within this number of seconds are batched.
If job batching is enabled:
• The job information displayed on the copier for batched jobs is not correct, because the
jobs are considered one job. Command WorkStation and the Job Log show the correct
information for the individual jobs.
• After printing has completed, the job status remains Printing until the Job Batching Delay
has expired.
• Color jobs are not batched with grayscale or black-and-white jobs.
• Jobs with the Save Fast Reprint option selected and jobs printed through the Print and
Hold command in Command WorkStation are not batched. They are always printed as
individual jobs.