Konica Minolta Darwin VDP Software - Manual (Page 64)

Page 64 of 92
T EC - I T B a r c o d e So f t w a re R e f e re n c e
6.4 GS1 DataBar (RSS) Symbologies
The sample control sequences refer to the following TEC-IT products only: TBarCode/X and
TBarCode Embedded (SEH ISD 300).
6.4.1 GS1 DataBar (RSS-14)
Symbology number (: 29
Valid characters: “0”..”9”
Quiet zone: none required (1X recommended)
Module width: --
Print ratio: 1:2:3:4:5:6:7:8:9:1:2:3:4:5:6:7:8:9
Ratio format: 1B:2B:3B:4B:5B:6B:7B:8B:9B:
1S:2S:3S:4S:5S:6S:7S:8S:9S
Default check digit: EAN 14 (eCDEAN14)
Possible check digits: User supplied
Symbol size: 13 digits, 1 check digit, AI 01 is encoded
automatically
(01)01234567890128
GS1 DataBar is used to encode the GTIN (Global Trade Item Number) with Application identifier
(AI) “01“. The GTIN consists of a packaging indicator (0..9) followed by a 12 digit number (taken
from the EAN-13 article number system) followed by a check digit. The check digit on the 14
th
posi-
tion is computed automatically if not provided in the input data.
The height of the symbol should be at least 33X to support omni-directional scanning (X = module
width). TEC-IT software p
refixes the barcode data with the AI “01” automatically - do not provide the
AI 01 with your input data.
6.4.2 GS1 DataBar Truncated (RSS-14 Truncated)
Symbology number: 78
Valid characters: “0”..”9”
Quiet zone: none required (1X recommended)
Module width: --
Print ratio: 1:2:3:4:5:6:7:8:9:1:2:3:4:5:6:7:8:9
Ratio format: 1B:2B:3B:4B:5B:6B:7B:8B:9B:
1S:2S:3S:4S:5S:6S:7S:8S:9S
Default check digit: EAN 14 (eCDEAN14)
Possible check digits: User supplied
Symbol size: 13 digits, 1 check digit, AI 01 is encoded
automatically
(01)01234567890128
This symbology is similar to GS1 DataBar but the height should be at least 13X. Omni-directional
scanning may not be possible.