Konica Minolta bizhub C3350 - Manual (Page 22)

[Applied Functions] 1-16
1.5 Available operations in Administrator mode 1
[Maintenance] - [Reset]
To display: Administrator mode - [System] - [Maintenance] - [Reset]
Resets the controller.
[Notification Settings] - [Status Notification Settings]
To display: Administrator mode - [System] - [Notification Settings] - [Status Notification Settings]
If a warning, such as paper addition, toner replacement, or paper jam, occurs on this machine, it can be sent
to a registered E-mail address.
[All Settings] Initializes the all settings.
When this option is selected, this machine restarts automatically.
Item Description
Item Description
[IP Address] Specify the destination IP address to send a notification of the machine status
using the SNMP TRAP function.
For details on how to specify the SNMP TRAP function, refer to page 1-55.
[Notification Ad-
dress] Enter the IP address (IPv4), IP address (IPv6), or host name.
[Port Number] If necessary, change the port number.
[162] is specified by default.
[Community Name] Enter the community name.
[public] is specified by default.
[E-mail Address] Specify the destination E-mail address to send the machine status via E-mail.
For details on the E-mail environment settings, refer to page 2-2.
[Notification Ad-
dress] Enter the E-mail address as a destination (using ASCII characters of up to 320
bytes).
[Alert] Select an item to be notified automatically.
[Paper Empty] Select whether or not to send a notification when the tray is out of paper.
[Enable] is specified by default.
[Paper Jam] Select whether or not to send a notification when a paper jam occurs.
[Enable] is specified by default.
[Maintenance] Select whether or not to send a notification when periodic inspection is re-
quired.
[Enable] is specified by default.
[Toner Out] Select whether or not to send a notification when toner runs out.
[Enable] is specified by default.
[Output Tray Full] Select whether or not to send a notification when the output tray is overloaded.
[Enable] is specified by default.
[Fuser Unit End] Select whether or not to send a notification when the finishing unit must be re-
placed.
[Enable] is specified by default.
[Operator Call] Select whether or not to send a notification when an error occurs.
[Enable] is specified by default.
[Service Call] Select whether or not to send a notification when a service call occurs.
[Enable] is specified by default.
[Job Complete] Select whether or not to send a notification when a job is completed.
[Enable] is specified by default.
[Job Error] Select whether or not to send a notification when a job has terminated abnor-
mally.
[Enable] is specified by default.