Konica Minolta bizhub 750 - Manual (Page 401)

Troubleshooting 11
IC-202 11-4
Stapling cannot be
performed. Number of sheets which can be
stapled is 100 of FS-505 and 50 of
FS-504/602 on A4 or smaller plain
paper. Change the Copies setting.
Number of pages that can be
center-stapled when FS-602 is in-
stalled: Up to 20 pages of plain
paper.
Stapling is not possible if the doc-
ument contains pages of different
sizes. Check the document.
The stapling position
is not as expected. The orientation setting is not cor-
rect. Check the stapling position in the
printer driver setup dialog box.
The hole punch func-
tion cannot be speci-
fied. Hole punching cannot be speci-
fied if [Booklet], [Transparency] is
selected. Check each setting in the printer
driver.
If optional finisher (excepting SF-
601) is installed, in addition, the
Punch kit or Punch Z-Fold Unit
should have been installed. Install the required optional finish-
er and enable it using the printer
driver.
The pages are not
punched. Printed pages may be fed out
without being punched if the pa-
per is loaded into the paper
source with an incorrect orienta-
tion. Check the orientation setting.
The hole punch posi-
tion is not as expect-
ed. The orientation setting is not cor-
rect. Check the punch position on the
Layout tab of the printer driver
setup dialog box.
The form is not printed
properly. Available computer memory
space is not sufficient. Simplify the form to reduce the
data size.
The image is not print-
ed properly. Available computer memory
space is not sufficient. Simplify the image to reduce the
data size.
Paper is not fed from
the specified paper
source. Paper will not be fed from the
specified paper source if that pa-
per source is loaded with paper of
a different size or orientation. Load the paper source with paper
of the appropriate size and orien-
tation.
Symptom Probable Cause Action