Konica Minolta bizhub PRO 1050P - Manual (Page 33)

8. Offset – selects if copies are offset in the output tray for easy
separation.
Note: Offset is performed per set, i.e. for multiple copies of a multi
page job, offset is performed after each copy.
9. N to 1 – outputs the pages in reverse order.
N to 1 is applied after imposition has been performed. See also
“Page order” in section “Print Properties”.
N to 1 is not allowed with Center Staple and Fold, Trim or with
Face up.
10. Face up – selects if copies are output face up.
Face up turns each sheet upside down on output. So if you print a
simplex job of n pages face up, then page n will be on top, and
page 1 at the bottom.
Face up is applied after imposition has been performed. See also
“Page order” in section “Print Properties”.
11. Creep Compensation – compensates for creep, i.e. the effect that
outer pages of a booklet do not line up with the inner pages when
they are folded. To align bitmaps on the pages, the bitmaps of outer
pages are moved outwards on the sheet. Creep compensation is
applied in addition to gutter.
Allowed values are 0 to 5 mm (step 0.01 mm) creep compensation
per sheet.
12. Gutter – determines a fixed margin to be applied between the two
document pages of an imposition which are printed on the same
side of a sheet.
Allowed values are -250 to 250 mm (step 0.1 mm). Each page is
shifted by the given amount, i.e. the resulting margin is twice the
specified value. A negative gutter shifts both pages to and clips
them at the center of the page.
Konica Minolta bizhub PRO 1050 Printer Driver Windows Printing
• 33