beautypg.com

Warning for setting of header and footer, Ic cs-03-telecommunication devices – Konica Minolta bizhub 161f User Manual

Page 25

background image

1

1.2 Regulation Notices

1-12

bizhub 161f

Int

ro

duc

tio

n

Chap

ter

1

This equipment may not be used on coin service provided by the telephone
company. Connection to party lines is subject to state tariffs. (Contact your state
public utility commission or corporation commission for information.)

Customer Information For Privately Owned Coin Phones

To comply with state tariffs, the telephone company must be given notification prior
to connection.

In some states, prior approval of connection must be obtained from the state Public
Utility Commission, Public Service Commission or state Corporation Commission.

Warning For Setting Of Header And Footer

The telephone Consumer Protection Act of 1991 makes it unlawful for any person
to use a computer or other electronic device to send any message via a telephone
fax machine unless such message clearly contains in a margin at the top or bottom
of each transmitted page or on the first page of the transmission, the date and time
it is sent and an identification of the business or other entity, or other individual
sending the message and the telephone number of the sending machine or such
business, other entity, or individual.

In order to program this information into your fax machine, you should complete the
following steps. (Refer to Chapter 7, page 7-59 and page 7-62)

IC CS-03-Telecommunication Devices

The following note shall be conspicuously placed in the user manual: The team “IC:”
before the certification/registration number only signifies that the Industry Canada
technical specifications were met.

NOTICE:
This equipment meets the applicable Industry Canada Terminal Equipment
Technical Specifications.

This is confirmed by the registration number. The abbreviation, IC, before the
registration number signifies that registration was performed based on a
Declaration of Conformity indicating that Industry Canada technical specifications
were met. It does not imply that Industry Canada approved the equipment.

Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the company’s inside wiring associated with a single line individual
service may be extended by means of certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.

This manual is related to the following products: