Electrical parameter measurement – WIKA Pascal ET User Manual
Page 44
6 Commissioning, operation
44 WIKA Operating Instruction, Pascal ET and Pascal ET/IS
GB
6.3.2.3 Electrical parameter measurement
The following procedure shows the settings of Pascal ET or Pascal ET/IS for the electrical
parameters measurement through the input module. To select the channel press on one of the four
large displays, then press CHANNEL: once menu is displayed press ASSIGN. Procedure is shown
below:
Figure 43 - Channel assign selection
Automatically the program shows the following configuration and it remains in this position till the
operator selects the parameter to be associated to the Channel 1.
For example, press mA for current measurement.
Figure 44
– mA parameter selection
See also other documents in the category WIKA Measuring instruments:
- 890.09.2190 (44 pages)
- A-10 (96 pages)
- A2G-50 (52 pages)
- A2G-55 (36 pages)
- AC-1 (88 pages)
- C-2 (24 pages)
- D-10-7 (112 pages)
- D-20-9 (51 pages)
- D-20-9 (35 pages)
- DG-10 (112 pages)
- DP-10 (44 pages)
- DPT-10 (96 pages)
- DPT-10 (92 pages)
- GCS-1 (76 pages)
- HP-2 (84 pages)
- IL-10 (31 pages)
- IPT-10 (56 pages)
- IPT-10 (48 pages)
- IPT-10 (28 pages)
- IPT-10 (36 pages)
- IS-20-F (7 pages)
- IS-20-F (43 pages)
- IS-20-H (7 pages)
- UT-10 (42 pages)
- UT-10 (52 pages)
- IUT-10 (78 pages)
- LH-10 (60 pages)
- LH-20 (60 pages)
- LS-10 (60 pages)
- MG-1 (92 pages)
- MH-1 (11 pages)
- MH-2 (9 pages)
- MHC-1 (84 pages)
- N-10 (35 pages)
- O-10 (108 pages)
- OT-1 (60 pages)
- P-30 (92 pages)
- PSA-31 (124 pages)
- PSD-30 (128 pages)
- R-1 (92 pages)
- S-10 (35 pages)
- S-11 (102 pages)
- S-20 (52 pages)
- S-20 (96 pages)
- SL-1 (21 pages)