WIKA Pascal ET - Manual (Page 16)

5 Transport, packaging and storage
16 WIKA Operating Instruction, Pascal ET and Pascal ET/IS
GB
5 Transport, packaging and storage
5.1 Transport
Check the Multichannel Calibrator model Pascal ET or Pascal ET/IS for any damage that may
have been caused by transport. Obvious damage must be reported immediately.
5.2
Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. sending for
calibration).
5.3
Storage
Permissible conditions at the place of storage:
■
Storage temperature: -30 ... +80 °C
■
Relative Humidity: 10 ... 90 % r. H. (non-condensing)
Avoid exposure to the following factors:
■
Direct sunlight or proximity to hot objects
■ Mechanical vibration, mechanical shock (putting it down hard)
■ Soot, vapour, dust and corrosive gases
■
Potentially explosive environments, flammable atmospheres
Store the instrument in its original packaging in a location that fulfills the conditions listed above. If
the original packaging is not available, pack and store the instrument as described below:
1. Wrap the instrument in an antistatic plastic film.
2. Place the instrument, along with shock-absorbent material, in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag, containing a
desiccant, inside the packaging.