WIKA Pascal ET - Manual (Page 39)

6 Commissioning, operation
WIKA Operating Instruction, Model Pascal ET and Pascal ET/IS 39
GB
6.3.2.2 Thermocouple signal measurement
The following procedure shows the setup of Pascal ET or Pascal ET/IS for temperature signal
measurement, for example, through a thermocouple connected to the input module. The channel
for measurement is selected by pressing one of the four large displays, once the menu CHANNEL
is selected, press ASSIGN as shown in the below figure.
Figure 31 – Channel assign selection
Automatically the program shows the following screen and it remains in this position until the
operator selects the type of parameter he desires to associate to the Channel 1.
Figure 32 – Temperature parameter selection