WIKA Pascal ET - Manual (Page 30)

6 Commissioning, operation
30 WIKA Operating Instruction, Pascal ET and Pascal ET/IS
GB
Automatically the program shows the following screen and remains in this position till the operator
select what type of parameter to associate to Channel 1.
Figure 12 – Parameter selection
The possible choices are:
■ V (Voltage)
■ mA (Current)
■ 
(Resistance)
■ Hz (Frequency)
■ Sw (Switch (Open/Closed))
■
T (Temperature)
■
P (Pressure)
■ HART (Hart communication) [Only when the module is fitted]
■ PULSE (Pulse)
■
NONE (No selection)
Previous set-up
A small black square in the top right side of the selection of the
Figure 12
– Parameter selection, NONE, shows the last configuration of the selected
channel. To maintain the same setting press NEXT.