Kramer Electronics VP-81KSi - Manual (Page 44)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Kramer Protocol
40
Machine info commands
Reset configuration
to factory default
FACTORY FACTORY RESULT
Identification commands
Command Syntax Response
Protocol Handshaking # CR ~OK CRLF
Read device model MODEL? MODEL MACHINE_MODEL
Read device serial number SN? SN SERIAL_NUMBER
Read device firmware
version
VERSION? VERSION MAJOR .MINOR .BUILD .REVISION
Set machine name NAME MACHINE_NAME NAME MACHINE_NAME RESULT
Read machine name NAME? NAME MACHINE_NAME
Reset machine name to
factory default*
NAME-RST NAME-RST MACHINE_FACTORY_NAME RESULT
*Note: machine name not equal to model name. This name relevance for site viewer identification of specific machine or for
network using (with DNS feature on).
MACHINE_NAME = Up to 14 Alfa-Numeric chars.
*
Machine factory name = Model name + last 4 digits from serial number.
Set machine id number MACH-NUM
MACHINE_NUMBER
MACH-NUM OLD_MACHINE_NUMBER
,NEW_MACHINE_NUMBER RESULT
* Response will send after machine number has been changed. So the replay with header will be:
NEW_MACHINE_NUMBER @ MACH-NUM OLD_MACHINE_NUMBER ,NEW_MACHINE_NUMBER OK
Network settings commands
Set IP Address NET-IP IP_ADDRESS
NTIP
NET-IP IP_ADDRESS RESULT
Read IP Address NET-IP?
NTIP?
NET-IP IP_ADDRESS
Read MAC Address NET-MAC?
NTMC
NET-MAC MAC_ADDRESS
Set subnet mask NET-MASK SUBNET_MASK
NTMSK
NET-MASK SUBNET_MASK RESULT
Read subnet mask NET-MASK?
NTMSK?
NET-MASK SUBNET_MASK
Set gateway address NET-GATE GATEWAY_ADDRESS
NTGT
NET-GATE GATEWAY_ADDRESS RESULT
Read subnet mask NET-GATE?
NTGT?
NET-GATE GATEWAY_ADDRESS
Set DHCP mode NET-DHCP DHCP_MODE NET-DHCP DHCP_MODE RESULT