Kramer Electronics VP-81KSi - Manual (Page 14)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-81KSi 8x1 UXGA/Audio STEP-IN Switcher
10
5. Connect the RJ-45 AV ON CAT 5 output connector to a compatible TP
receiver (for example, TP-120).
6. Connect the unbalanced audio 3.5mm AUDIO OUTPUT jack to an
unbalanced audio acceptor (for example, power amplifier).
7. Connect the balanced audio 5-pin terminal block (see Section 6.1 ) to an audio
acceptor 1
8. Connect up to eight remote, contact closure input selection switches to the
REMOTE terminal block (see
.
Section 6.2
9. Connect a PC over a LAN to the Ethernet for remote operation.
).
10. Set the DIP-switches (see Section 6.6.1
 RS-232 port (see
) for remote operation. You can
connect a PC and/or controller to the:
Section 6.3
 RS-485 port (see
)
Section 6.6.1
11. Connect
)
1 the power cord 2
6.1 Connecting the Balanced/Unbalanced Stereo Audio Output
.
This section illustrates how to wire the devices to the balanced audio output:
• A balanced stereo output connection, see Figure 4
• An unbalanced stereo output connection, see Figure 5
Figure 4: Balanced Stereo Audio Connection
Figure 5: Unbalanced Stereo Audio Connection
1 Not shown in the illustration
2 We recommend that you use only the power cord that is supplied with this machine