Agilent Technologies N9340A - Manual (Page 126)

6 SCPI Command Reference
124 N9340A User’s Guide
SENSe Subsystem
Sets the instrument parameters for the input signal
measurements.
[:SENSe]:AVERage Subsection
Average Type
[:SENSe]:AVERage:TYPE
LOgPower|POWer|VOLTage
[:SENSe]:AVERage:TYPE?
This command sets the average type to the
following three types:
• Log Pwr
• Power
• Voltage
For more information about the three types of
average above, please refer to
“Avg Type"
on page 72
Clear the current Average
[:SENSe]:AVERage:TRACe 1|2|3|4|5|6:CLEar
This command restarts the trace averaging
function.
*RST State:
Log Pwr
Range:
Log Pwr, Pwr, Voltage
Key Access: [BW/SWP] > {Avg Type}
NOTE
Restart the trace at the beginning of a sweep to obtain valid
average data. To do this remotely abort the sweep and initiate
a single sweep.