Agilent Technologies N9340A - Manual (Page 104)

6 SCPI Command Reference
102 N9340A User’s Guide
Control Limit line Buzzer
:CALCulate:LLINe[1]:BUZZer[:STATe]
OFF|ON|0|1
:CALCulate:LLINe[1]:BUZZer[:STATe]?
This command toggles the audio warning between
on and off. If data exceeds the limit line the buzzer
will sound an alarm.
Control Limit Line Testing
:CALCulate:LLINe[1]:[STATe] OFF|ON|0|1
:CALCulate:LLINe[1]:[STATe]?
This command toggles the limit line testing
between on and off.
If the limit line is turned on, limit pattern is
automatically turned off.
Set Limit Line Y-axis value
:CALCulate:LLINe[1]:Y
:CALCulate:LLINe[1]:Y?
This command sets limit line Y- axis value.
Limit line Y- axis value is set independently without
affected by the X- axis Units.
*RST State:
Off
Key Access: [Limit] > {Beep}
*RST State:
Off
Key Access: [Limit] > {Limit Line}
*RST Value:
0 dBm
Available Unit:
dBm, -dBm, mV, uV
Key Access: [Limit] > {Limit Line}