Agilent Technologies Agilent 4396B - Manual (Page 87)

5
Network Measurement Examples
This chapter contains the following network measurement examples:
Transmission Measurement
3 dB bandwidth
Ripple or
atness
Magnitude and phase characteristics
Expanded phase characteristics
Electrical length measurement
Phase distortion measurement
Deviation from linear phase
Group delay
Re
ection measurement
Return loss
Re
ection coecient
Standing wave ration (swr )
S-parameters measurement
Impedance and admittance measurement
List sweep
Sweep time reduction
Dynamic range enhancement
Filter testing using limit line
Gain compression measurement
Basic Setup All the examples described in this chapter use the 85046A/B
S-parameter T est Set to connect to the device under test (dut). This
approach simplies the measurement setup .
Example DUT The DUT used in the examples in this chapter is a dielectric bandpass
lter with a 836 MHz center frequency . If you use your own DUT ,
modify the parameter values (measurement frequency range , signal
level, etc .) as appropriate for your DUT .
Network Measurement Examples 5-1