Agilent Technologies Agilent 4396B - Manual (Page 109)

1. Press 4 System 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
LIMIT MENU
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
LIMIT LINE on OFF to
NNNNNNNNNNNNNNNNNNNN
ON off .
2. Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
EDIT LIMIT LINE
NNNNNNNNNNNNNN
EDIT .
3. F or segment 1:
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SWP PARAM VALUE 806 4 M/ 5 .
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
UPPER LIMIT 055 4 21 5 .
Press
N NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
LOWER LIMIT 0120 4 21 5
N NNNNNNNNNNNNN
DONE .
4. F or segment 2:
Press
NNNNNNNNNNN
ADD
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SWP PARAM 821 4 M/ 5 .
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
UPPER LIMIT 01 4 21 5 .
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
LOWER LIMIT 015 4 21 5
NNNNNNNNNNNNNN
DONE .
5. F or segment 3:
Press
NNNNNNNNNNN
ADD
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SWP PARAM 851 4 M/ 5
NNNNNNNNNNNNNN
DONE .
6. F or segment 4:
Press
NNNNNNNNNNN
ADD
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SWP PARAM 866 4 M/ 5 .
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
UPPER LIMIT 055 4 21 5 .
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
LOWER LIMIT 0120 4 21 5
NNNNNNNNNNNNNN
DONE .
7. Press
NNNNNNNNNNNNNN
DONE .
The limit line segments do not have to be entered in any particular order . The
analyzer automatically sorts them and lists them on the display in the increasing
order of sweep parameter value .
Figure 5-20. Editing the Limit Lines
P erforming Limit T est
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
LIMIT TEST on OFF to
NNNNNNNNNNNNNNNNNNNN
ON off to perform limit testing using
the limit lines you just edited. When the limit lines and testing are
turned on, an out-of-limit test result is normally indicated in six ways:
With a F AIL message on the screen.
With a beep (on/o selectable).
With an asterisk in tabular listings of data (under 4 Copy 5 ).
With a bit in GPIB event status register B .
Network Measurement Examples 5-23