Troubleshooting/repair, Others – Nikon COOLSHOT User Manual

Page 19

Others

This Nikon Laser Rangefinder is a basic rangefinder. Its results cannot be used as official evidence.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

　• Reorient or relocate the receiving antenna.

　• Increase the separation between the equipment and receiver.

　• Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Troubleshooting/Repair

If your Nikon Laser Rangefinder should require repair, please contact your local dealer or the store where you

purchased it. Before doing so, you are advised to consult the Troubleshooting/Repair Table below.

Symptom

Check Points

Unit does not turn on

(LCD fails to illuminate)

●

Depress POWER ON/Measurement button. (near side, top of the body)

●

Check the battery insertion

●

Replace the battery with a new one.

Unable to measure the distance

●

Be sure that nothing, such as your finger or a strap, is blocking the

laser emission aperture and laser detector aperture on the objective

lens side.

●

Be sure that the laser emission aperture and laser detector aperture

on the objective lens side are clean. Clean them if necessary.

●

Be sure that the target shape and condition are appropriate to reflect

the laser beam.

●

Replace the battery with a new one.

[- - -] (“Cannot measure”) appears

●

Be sure to hold the unit steady while measuring.

●

Be sure the target is within measurement range

Measurement range: 4.5-550m/5-600 yards

Closer target, located inside the

measurement range, cannot be

measured

●

Be sure that nothing, such as leaves or grass, is between the Nikon

Laser Rangefinder and the target.

Target beyond a certain distance

cannot be measured

●

Be sure that nothing, such as leaves or grass, is between the Nikon

Laser Rangefinder and the target.

Measurement result is unstable

●

Replace the battery with a new one.

●

Be sure that the target shape and condition are appropriate to reflect

the laser beam.

●

Be sure to hold the unit steady while measuring.

●

Be sure that nothing, such as leaves or grass, is between the Nikon

Laser Rangefinder and the target.