Nikon COOLSHOT User Manual

Page 15

Internal display

Distance

Unit of measure (m/yd.)
Target mark

Laser irradiation mark
Height

(Actual distance at Golf mode setting)

Battery condition

Incline

Decline

First Target Priority mode

Distant Target Priority mode

Measurement display mode

1. Turn on the power (Confirm the internal display

is on).

2. Press and hold the MODE button, then

immediately (less than 0.5 second) depress the

POWER ON/Measurement button for less than 2

seconds.

3. Release your finger from the POWER

ON/Measurement button to switch the

Measurement display mode.

4. Repeat steps 2 and 3 until your desired mode is

displayed.

* If the buttons are not pressed in the correct

order, switching will not take place.

* Switching the mode after measurement

converts the results to the new mode.

* After the mode is set, measurements are

performed in the new mode.

Press and hold the MODE button, then immediately depress the POWER ON/Measurement button (less

than 2 seconds) to change the mode in the order shown below.

Actual Distance

and Height Mode

Horizontal Distance

and Height Mode

Golf Mode

Actual Distance

Mode

Actual

Distance
Height

Horizontal

Distance
Height

Slope

Adjusted

Distance
Actual

Distance

Actual

Distance

『

』 - Aim at the target you want to measure. Position the target at the center of the reticle.

『

』 - Appears while the laser is being irradiated for a measurement.

Remains present during single measurement. Blinks during continuous measurements.

Do not look into the objective lens while this mark is shown.

『』 - Now measuring

『

』 - "Failure to measure" or "Unable to measure"

* Usually, an LCD employs equal or lower magnification. However the LCD of this product is magnified

by the high magnification of the eyepiece. Although this LCD was produced using the most advanced

technology, it is impossible to eliminate dust completely. As a result, dust may be seen. It will not,

however, affect measurement accuracy or safety during use.