Swiftech H20 120 R3A - Manual (Page 36)

Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:
[email protected] – URL: http://www.swiftnets.com
Square cut
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
c. Spread a little bit of grease or liquid
soap
around the tubing. It helps pushing the
tubes in, particularly with Clearflex  tubing,
which features a very “sticky” surface.
d. Fully insert both tubes into the fittings. The tip of the plastic tube inserts should
be flush with the inlet and outlet openings, as shown in figure 4 above. Inserting the
tubes requires a firm push, accompanied by a twisting motion.
2. I NSTALLATION FOR I NTEL  PLATFORMS
- Information subject to change without notice Page 36 of 38
a. Prepare your Motherboard
Remove the existing heat sink
Carefully clean the processor, using alcohol
Install the 4 neoprene pads as shown figure 8. This
step is only necessary if the processor core is
exposed. If the chipset features a heat spreader
(a large lid covering the entire area of the
chipset), then the neoprene pads MUST not be
installed.
Lightly coat the CPU with the included Arctic
Céramique thermal compound. Application will vary
depending on the type of processor. We
recommend visiting http://www.arcticsilver.com for
detailed instructions.
Figure 8