Swiftech MCX159 User Manual
Figure 1
Copyright Swiftech 2003 – All rights reserved – Last revision date: Sep 15, 2003
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769
E Mail: Swiftech @swiftnets.com – URL:
http://www.swiftnets.com
Page 1
Packing list
Parts Qty
Parts
Qty
Heat Sink
1
4-40 x 1.25” Philips screws
2
40mm fan
1
4-40 mini nuts
2
4-40 x 2.25” Philips screws
2
Knurled knob
2
Black fiber washers
6
Thermal grease – Arctic Alumina
1
Nylon tension limiter
2
Spring
2
I. Heat sink Installation
1.
Installation necessitates removal of the motherboard from the chassis.
2.
Follow Figure 1 below to install the retention rods: install two 4-40 x 1.25” Philips screws with fiber washers on either side of the
motherboard, and secure with 4-40 mini-nuts.
Figure 1
4-40 x 2.25" philips screw
Fan
Knurled knob
Spring
Tension limiter
4-40 mini-nut
Black fiber washer
Motherboard
Black fiber washer
4-40 x 1.25" philips screw
Heatsink
Information subject to change without notice