Swiftech MCX370 User Manual
Swiftech Computer Accessories
Copyright Swiftech 2001 – All rights reserved – Last revision date: Oct. 2001
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90806 – Tel. 562-595-8009 – Fax 562-595-8769
E Mail: Swiftech @swiftnets.com – URL:
http://www.swiftnets.com
Information subject to change without notice
Page 1
Packing list
Parts Qty
Parts
Qty
Heat Sink
1
Nylon spacers
2
Fan
NO
Long spring
1
6-32 x 2 ½ ” screws (for fan)
4
Short spring
1
6-32 x 1” screws (for HS)
2
Rubber washers
8
Clips 2
Thermal
grease
1
Compatible with AMD® Duron™, Athlon™, MP, XP 2000 & higher, and Intel® Pentium™ III processors
II. Heat sink Installation
Thermal compound
here
•
We recommend that you lay down your computer flat on a table.
•
Lightly coat the processor core with the included thermal compound.
Only a paper thin coat is necessary. It should be applied using
preferably a razor blade, or a credit card, held between thumb and
index at a 45 degree angle. It is critical to ascertain that the entire core
is covered with a uniform coat of thermal compound. Thermal
performance will dramatically decrease if any portion of the core is not
covered by thermal compound.
I. Assembly schematic
6-32 x 2 1/2“ screw
Fan
6-32 x 1 1/2“
screw
Clip
Long
spring
Short
spring
Rubber washer
Fan air flow
direction
Step in heat sink base
Nylon spacer
To power supply
Heat sink