Swiftech MCX603 V 1-10-04 User Manual
Airflow direction
Packing list
Parts Qty
Parts
Qty
Heat Sink
1
Push-pin rivets (standard)
4
80mm fan brackets
4
Thermal grease – Céramique
1
1.
Processor Preparation
Lightly coat the CPU with the provided
Céramique™ thermal compound. Detailed
instructions can be found at
s.htm
Rub some
compound in
base of water-
block first, and
then clean off
with lint-free
cloth.
Apply small
amount of
compound on
the CPU heat
spreader
2.
Heatsink installation
The MCX603-V
heatsink uses Intel’s validated retention clips,
which are provided with your motherboard. It does not
necessitate removal of the motherboard. Please consult your
motherboard user’s manual for installation of the retention frame
and clips.
Note: on one side of the heatsink, the outmost row of pins has
been removed. This provides clearance for installation of two
MCX603-V
heatsinks in side-by-side, dual processor
configurations.
Simply place the heatsink onto the CPU, and push down on the
spring clips to secure the assembly.
TIP: press down on the opposite side of the heatsink while
installing the first clip, to prevent the assembly from tilting.
3.
Alternate retention
Swiftech’s optional proprietary retention mechanism (spring
loaded screws & standoffs) is also available online. Information is
available on our site
Airflow direction
Copyright Swiftech 2003 – All rights reserved – Last revision date 11-24-04
Rouchon Industries, Inc., dbA Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769
E Mail: Swiftech @swiftnets.com – URL:
http://www.swiftnets.com
Information subject to change without notice
Page 1