Hubbardton Forge 307530 - Manual (Page 2)

Installation Instructions
B139
For Large Ellipse Outdoor Wall sconce 30-7530 & 307530F Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21181
To Install Glass (Figures 3 & 4)
Component Parts
C Fixture
F Screws
(3)
G Glass
H Washer
I Retaining
Ring
J Socket
1. Unthread screws (F) that are shipped installed in threaded tubes on
underside of fixture next to socket (J). Loosen screws until there are
only a couple threads engaged with the threaded tubes.
2. Raise glass (G) and washer (H) over socket (J) aligning holes in washer
(H) so the washer keyed ring goes over screws (F).
3. Turn washer (H) counter clockwise until it stops. Tighten three screws
(F) until snug against the inside of glass (G). Be careful not to over
tighten.
4. Thread retaining ring (I) on to socket (J) until snug against washer (H).
Note: Retaining ring alone is not enough to hold glass permanently.
5. Install light bulb. (For fluorescent version bulb is supplied.)
6. Restore electricity at the main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 3)
(Figure 4)