Hubbardton Forge 307530 - Manual

Installation Instructions
B139
For Large Ellipse Outdoor Wall sconce 30-7530 & 307530F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21181
For fixtures requiring assembly, please refer to assembly instructions before installation.
To Install Fixture
Component Parts
A Cross Bar
B Threaded Studs (2)
C Fixture
D Barrel Knobs (2)
E Caulking
Lip
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the
carton.
2. Using two machine screws (not
provided) attach cross bar (A) to the
electric box using inside oval holes to
orient fixture.
Note: A new electric
box comes with screws. When
replacing a fixture, retain the screws
for use with the new fixture.
3. Start threaded studs (B) into
appropriate holes in crossbar (A).
4. Using suitable wire connectors (not
provided), connect the fixture wires to
the supply wires, (white to white,
black to black, bare copper or green to
bare copper or green). If the fixture is wired
with twin lead lamp cord, connect the ribbed side to
white, and the smooth side to black.
Caution: Make sure wire connectors are twisted on
securely and no bare wires are exposed.
5. Apply a generous bead of a suitable caulking material to
caulking lip (E) on the fixture.
6. Carefully tuck all wires behind the fixture. Place fixture
(C) over threaded studs (B) and tighten firmly to
mounting surface using barrel knobs (D).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)