Hubbardton Forge 307115 - Manual (Page 2)

Installation Instructions
B165
For Outdoor Sconces 30-7115 & 30-7115F Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22507
To Install Glass (Figure 3)
Component Parts
A Fixture
I Top
Hat
J Thumb Screw (2)
K Glass
1. Install light bulb. (Fluorescent fixtures are supplied with bulb)
2. Slide glass (K) into fixture (A). Open slot goes toward wall so it slips
into grooves on fixture (A).
3. Attach top hat (I) onto fixture (A) with two thumb screws (J). Do not
tighten thumb screws at this point.
4. Adjust top hat (I) until it rests on top of glass (K).
5. Tighten by hand thumb screws (J) until snug against top
hat (I). Be careful not to over tighten.
6. Restore electricity at the main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 3)