Hubbardton Forge 126751 - Manual (Page 2)

Assembly & Installation Instructions
A158
For Impressions Semi-Flush 12-6751 & 12-6751F Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21236
To Install Glass (Figures 2 & 3)
Component Parts
F Glass
G Spider
Assembly
H Socket Assembly
I Screws (3)
J Diffuser
K Washer
1. Place glass (F) into notches of spider assembly (G)
(Figure 2).
2. Lift spider assembly (G) with glass (F) installed over socket
assembly (H) and place on top of socket assembly.
3. Rotate spider assembly (G) until all three holes match up
with the three holes in washer (K).
4. Thread screws (I) from bottom of washer (K) into spider
assembly (G).
5. Install light bulbs. Fluorescent version bulbs are included.
6. Insert the diffuser (J) up into the fixture at an angle then
level it and gently lower onto the lowest tabs of the spider
assembly (G).
7. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)
(Figure 3)