Hubbardton Forge 126751 - Manual

Assembly & Installation Instructions
A158
For Impressions Semi-Flush 12-6751 & 12-6751F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21236
To Install Fixture (Figure 1)
Component Parts
A Ground Screw
B Cross Bar
C Threaded Stud (3)
D Canopy
E
Barrel Knobs (3)
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross
bar (B) to match hole centers in canopy (D). Move
ground screw (A) to another available threaded hole if
necessary.
3. Using two machine screws (not provided) fasten cross
bar (B) to the electric box using outer oval holes to
orient fixture to desired hanging position.
Note: A new electric box comes with screws. When
replacing an existing fixture, retain the screws for use
with the new fixture.
5. Using suitable wire connectors (not provided); connect
fixture wires to supply wires (white to white and black
to black). Connect all ground wires to green ground
screw (A).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Slide fixture canopy (D) over threaded studs and push
firmly to ceiling, making sure that no wires are
pinched between fixture canopy and ceiling. Fasten
with barrel knobs (E). Be sure studs (C) are fully
seated in barrel knobs (E).
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.