Hubbardton Forge 124560 - Manual (Page 2)

Assembly & Installation Instructions
A116
Compass Semi-Flush 124560 Page 2 of 2 _
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 19874 Rev B
2. Thread knurl ball (I) onto threaded rod (J) until snug against inside of canopy (F).
3. Slide fixture canopy (F) against ceiling, and secure with canopy ring (G).
To Install Glass Frame and Glass (Figure 3)
Component Parts
I Knurl Ball (4)
J Threaded Rod (4)
K Glass Frame
L
Tab
M Glass
1. Slip tabs on glass frame (K) onto three threaded rods (J) and
attach with knurl ball (I).
2. Slip glass (M) into glass frame (K) so it rests below the three
tabs.
3. Slip tab (L) onto last threaded rod (J) and slide onto glass
frame (K).
4. Thread knurl ball (I) onto threaded rod (J).
5. Install light bulbs (not provided).
6. Restore electricity at main breaker.
To Install Diffuser Glass (Figure 4)
Component Parts
N Diffuser Glass (2)
O Threaded Ball (4)
P Threaded Stud (4)
1. Slip diffuser glass (N) over threaded
stud (P).
2. Install threaded ball (O) on to
threaded stud (P) until snug against
diffuser glass (N). Be careful not to
over tighten.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 3)
(Figure 4)