Hubbardton Forge 124560 - Manual

Assembly & Installation Instructions
A116
Compass Semi-Flush 124560 Page 1 of 2 _
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 19874 Rev B
Install the Canopy (Figure 1)
Component Parts
A Crossbar
B Ground Screw
C Hex Nut
D Threaded Nipple E Coupling
F
Canopy
G Canopy Ring
H Socket Assembly
Caution: Be sure power is off at the main breaker box prior to installation.
1. Slip canopy ring (G) large diameter first over threaded nipple (D) and
thread on and over coupling (E) followed by canopy (F) coming to rest on
socket assembly (H).
2. Thread hex nut (C) and crossbar (A) onto threaded nipple (D), leave parts
loose.
3. Using two machine screws (not provided) fasten the crossbar (A) to the
electric box.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
4. Adjust the length of threaded nipple (D) in crossbar (A) so that canopy ring
(G) will hold canopy (F) against the ceiling with no threads showing for
best appearance. When the correct adjustment is established, tighten hex
nut (C) against crossbar (A) to hold the adjustment.
5. Loosen canopy ring (G) from coupling (E) and lower canopy ring (G) and
canopy (F) until they rest on top of socket assembly (H).
6. Using suitable wire connectors (not provided) connect fixture
wires to supply wires (white to white or ribbed and black to black
or smooth. Connect all ground wires to green ground screw (B).
Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and
no bare wire is exposed.
Install the Threaded Rods (Figure 2)
Component Parts
F Canopy
G Canopy Ring
I
Knurl Ball (4)
J Threaded Rod (4)
1. Slip bent end of threaded rod (J) through holes in canopy (F).
(continued)
(Figure 2)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)
(Figure 1)