B132, Installation & assembly instructions – Hubbardton Forge 217910 User Manual

Page 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

21128 Rev B

Installation & Assembly Instructions

Install Wall Mounting Bracket

(Figure 2)

Component Parts

C Wall Mounting Bracket

D Lag Screw (4)

E Anchors (2)

F #10 Screws (2)

1. Place the wall mounting bracket (C) over the electrical box

using the center hole provided being sure to hold it plum

and level. With a pencil, mark the location of all mounting

holes in the wall mount bracket on the wall behind.

IMPORTANT: Wall mounting bracket must be secured to a solid

framing member in at least four locations. Do not depend on dry
wall anchors alone to support this fixture. If in doubt, contact a
qualified electrician.

Set aside the wall mounting bracket and drill 1/4" holes

in the center locations marked on the wall. For holes using

anchors, place the tapered end of the anchors (E) into the

holes and gently tap them flush to the wall using a light

weight hammer.

2. Thread the wires in the electrical box through the hole in the

wall mounting bracket (C) while moving the bracket into

position. Using the 1" #10 screws (F), screw the bracket

securely to the wall. Be careful not to over-tighten or strip

the anchors.

3. Using four lag screws (D) attach wall mounting bracket

lag screws with your fixture; however, different materials

and/or construction methods may require different

fasteners. If in doubt, contact a qualified electrician. Do not

attach wall mounting bracket directly to outlet box.

B132

For Silhouette Sconces 217910F

Page 2 of 4

(Continued)

(Figure 2)