Hubbardton Forge 217910 User Manual

B132, Installation & assembly instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

21128 Rev B

Installation & Assembly Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

For fixtures requiring assembly, please refer to assembly instructions

before installation.

Please Note: This fixture is designed to be mounted on a standard

wall surface and may not be suitable for all applications. If installing in

a non-wood frame application, we recommend consulting a qualified

builder or electrician.

Prepare to Install

(Figure 1 & 1A)

Component Parts

A Fixture

B Screws (4)

P Front Plate

Q Allen Screws (4)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Remove the four Allen screws (Q) attaching the front plate

(P) to the fixture (A).

Note: There are magnets located in the center standoffs which
might come loose when the front plate is removed. If this happens
the magnets can be reattached by adding a little super glue and
pushing back into the standoff. See Figure 1A.

3. Remove four screws (B) from front of fixture to release wall

mounting bracket and discard screws.

B132

For Silhouette Sconces 217910F

Page 1 of 4

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 1)

(Continued)

REMOVE SCREWS
& SAVE

(Figure 1A)

REMOVE SCREWS
& DISCARD

MAGNET
STANDOFF