Hubbardton Forge 217720 - Manual (Page 3)

Installation & Assembly Instructions
B116
For Silhouette Sconces 21-7705F, 21-7710F, 21-7715F & 217720F Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19865 Rev C
To Install Bulbs (Figure 4)
Component Parts
P Socket
Q T2 Bulb (2 Each)
1. Slide bulb (Q) into Socket (p) making sure the bulbs seat
completely into socket oriented as shown. (See trouble shooting
solutions below).
If fixture does not light or blinks and then goes off try the following:
1. Make sure the bulbs are correctly installed into sockets. Push
gently on the ends of the bulbs to make completely sure the bulbs
are making contact with the sockets.
2. Check overall fit. Bulbs are designed to fit snugly into both
sockets. Too much clearance on either end could cause the bulbs
to arc and fail prematurely.
3. If fixture still will not light try removing both bulbs and
reinstalling them along with switching power off to the fixture.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 4)