Hubbardton Forge 217520 - Manual (Page 2)

Installation Instructions
B178
For Aperture Vertical Sconce 21-7520 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22738
To Install Glass (Figure 3)
Component Parts
B Front Assembly
J Glass (2)
K Glass Spring
1. Slide glass (J) into slots in front assembly (B) with the dull side towards the
center until the holes in the glass (J) engage with the glass spring (K).
To Install Front (Figure 4)
Component Parts
A Fixture Back
B Front Assembly
C Locking Screw
D Cap Screw (2)
L Bulb
(Included)
1. Install light bulb (L). Be careful not to touch bulb with bare hands; oil
from your hands will reduce bulb life.
2. Slip front assembly (B) onto two cap screws (D) by aligning top slot
and keyed slot with the cap screws (D) installed in fixture (A). When
front is as far back as it will go slide fixture down to secure.
3. Tighten locking screw (C) until snug.
If you need further assistance, or find that you are missing any parts, please
contact the dealer from which you purchased this product. We hope you enjoy
your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper
installation, lamping or use of this fixture.
(Figure 3)
(Figure 4)