Hubbardton Forge 217520 - Manual

Installation Instructions
B178
For Aperture Vertical Sconce 21-7520 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22738
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Please Note: After installation extra hardware and accessories are possible due to our kits are used on multiple products
and options.
To Mount Fixture to Wall (Figures 1 & 2)
Component Parts
A Fixture Back
B Fixture Front
C Locking Screw
D Cap Screw (2)
E Screw
Cap
F Nipple
G Lock
Nut
H Crossbar
I Ground
Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Remove fixture front (B) from fixture back (A) by loosening locking screw (C). Two
assemblies are shipped together. Slide fixture front (B) up to allow it to slip over
cap screws (D). Set aside for later use.
3. Using two machine screws (not provided) attach cross bar (H) to the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the
screws for use with the new fixture.
4. Thread the nipple (F) into the crossbar (H) and secure with lock nut (G).
Adjust the nipple to proper length to ensure the fixture will fit snugly to
the wall.
5. Using suitable wire connectors (not provided), connect the fixture wires
to the supply wires, (white to white, black to black, bare copper or green
to bare copper or green). Ground the crossbar using the green ground
screw (I) and securing a pigtail lead to the crossbar. If the fixture is
wired with twin lead lamp cord, connect the ribbed side to white, and the
smooth side to black. Caution: Make sure wire connectors are twisted
on securely and no bare wires are exposed.
6. Carefully tuck all wires behind the fixture back (A), place fixture back
firmly against the wall and fasten with screw cap (E).
7. See instructions following to complete install.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Figure 1
Figure 2