B273, Installation instructions – Hubbardton Forge 207790 User Manual

Page 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

27819 C

Installation Instructions

To Mount Fixture to Wall

(Figure 1)

(Continued)

4. Thread the black # 8 screws (E) up through the holes in the
top of the wall mount bracket (B). Leave the bottom screws
out for now.

5. Hold the fixture assembly (A) close to the wall mount

bracket and using suitable wire connectors (not provided),

connect fixture wires to supply wires (white to white or

ribbed and black to black or smooth, and bare copper or

green to bare copper or green). Ground the mounting

bracket using the green ground screw (F) and cupped

washer (G) to secure a pigtail lead to the bracket.

6. Carefully tuck all wires behind the fixture assembly and

inside the wall mount bracket and place the fixture over

the bracket so that the screws in the top of the wall bracket

go through the holes in the top of the fixture. Secure the

fixture by threading the remaining black #8 screws

up through the holes in the bottom of the fixture and into

the mounting bracket.

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRES ARE EXPOSED.

To Install Double Glass Option

(Figure 2)

Component Parts

A Fixture Assembly

H Ring

I Glass

J Bulb (Included)

1. Install light bulb (J). Be careful not to touch bulb with bare

hands; oil from the hands will dramatically reduce bulb life.

Note: The bulb included is based on our design preference; see

the fixture wattage sticker for Max wattage information.

2. Carefully lower the ring (H) around the inner tube of the

glass (I) until it rests on the bottom.

3. Install glass (I) by rotating it clockwise while holding the

fixture assembly (A) until it rests against the fixture. Do not

over tighten.

4. Restore electricity at main breaker.

B273

Sconce 207790

Page 2 of 3

(Figure 2)