Hubbardton Forge 207790 User Manual

B273, Installation instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

27819 C

Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

For fixtures requiring assembly, please refer to assembly instructions

before installation.

Please Note: This fixture is designed to be mounted on a standard wall

surface and may not be suitable for all applications. If installing in a non-

wood frame application, we recommend consulting a qualified builder

or electrician.

To Mount Fixture to Wall

(Figure 1)

Component Parts

A Fixture Assembly

B Wall Mount Bracket

C Anchors

D #10 Screws

E #8 Black Screws

F Green Ground Screw

G Cupped Washer

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Center the wall mount bracket (B) over the electrical box

being sure to hold it plum and level. With a pencil, mark

the location of all mounting holes in the wall mount bracket

on the wall behind.

Important: Wall mount bracket must be secured to a solidly

mounted electrical box and/or a framing member in at least two
locations. Do not depend on drywall anchors alone to support this
fixture. If in doubt, contact a qualified electrician.

Put the wall mount bracket down and drill 1/4" holes in the

locations marked on the wall. For holes using anchors, place

the tapered end of the anchors (C) into the holes and gently

tap them flush to the wall using a light weight hammer.

3. Thread the wires in the electrical box through the center hole

in the wall mount bracket while moving the bracket into

position. Using the #10 screws (D), screw the bracket

securely to the wall. Be careful not to over-tighten or

strip the anchors.

B273

Sconce 207790

Page 1 of 3

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 1)

(Continued)