Hubbardton Forge 205105 - Manual

Glass Installation Instructions
B22
Page 1 of 2
Your new lighting fixture has been shipped with the glass installed. It may be necessary to remove the glass when
installing the fixture.
To Remove Glass
1. Remove the knurled balls at the sides of the glass.
2. Remove the leaf assembly and glass from the screws. Remove one side at a time.
To Install Glass
Note: The bracket is slightly bent toward the wall. This provides tension in the bracket, which holds the glass securely to
the wall. The amount of tension may be adjusted by bending the bracket slightly as needed.
1. Place the hooked portion of the leaf
assembly over the front edge of the glass so
the curled ends of the leaf assembly line up
with the holes in the side of the glass.
2. Gently pull one side of the bracket away
from the wall and slide one side of the glass
and leaf assembly over the screw.
3. Attach the other side in the same manner
using a rocking motion. It is not possible to
attach both sides simultaneously.
4. Secure the glass and leaf assembly using the
knurled balls.
5. Adjust the glass to level by turning the two
adjusting screws as needed.
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14045