Hubbardton Forge 204915 - Manual (Page 2)

Installation Instructions
B208
For Twilight Sconce 20-4915 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24453
4. Slide fixture back (C) over threaded studs (E) and push firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with knurl balls (F). Be sure threaded studs (E) are fully seated in the
knurl balls (F).
5. See instructions following to complete installation.
To Install Glass (Figures 3, 4 & 5)
Component Parts
A Fixture Front
I Glass
J Set Screws (2)
K Glass Brackets (2)
1.
Using provided wrench loosen the two set screws (J)
installed in the fixture front (A) until they are below
the front plate where the glass is to be installed
(Figure 4).
2. Install glass (I) in fixture front (A) so it rests on the
glass brackets (K).
3. Using provided wrench install set screws (J) so they
are below the back of fixture front (A) (Figure 5).
(continued)
(Figure 3)
(Figure 4)
(Figure 5)