Hubbardton Forge 204825 - Manual (Page 2)

Installation Instructions
B170
For Sconce 20-4825 & 20-4825E Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22659
To Install Glass (Figures 2 & 3)
Component Parts
D Fixture Assembly
F Bracket
G 8-32 Screw (2)
H Hanger
Rod
I Glass
J Rubber tubing (2)
K Thumb Screw (2)
1. Slide hanger rod (H) into holes in glass (I) from the inside.
2. Move rubber tubing (J) outward on rod to secure rod in glass,
making sure the rod remains centered in the glass.
3. Install thumb screws (K) into bracket (F). Only a couple of
threads engaged at this time.
4. Place glass (I) with hanger rod installed into bracket. Make sure
tabs are pointing down. Some pressure is necessary to snap rod
into bracket. Check glass for level and adjust as needed by
loosening 8-32 screws (G) and moving bracket as needed. Once
glass is level tighten both 8-32 screws (G).
5. Tighten thumb screws (K).
6. Install light bulb. (Fluorescent supplied with fixture)
7. Restore electricity at main breaker.
(continued)
(Figure 2)
(Figure 3)