Hubbardton Forge 204901 - Manual

Installation Instructions
B199
For Rook Sconce 20-4901 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24349
Please Note: This fixture is designed to be mounted on a standard wall surface and may not
be suitable for all applications. If installing in a non-wood frame application, we recommend
consulting a qualified builder or electrician.
Please Note: After installation extra hardware and accessories are possible; our kits are
used on multiple products and options.
To Mount Fixture to Wall (Figure 1, 2 & 3)
Component Parts
A Crossbar
B 2”
Threaded Nipple
C Thin Lock Nut
D Thick Lock Nut
E Ground Screw
F Fixture
G Set
Screw
To Install
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Thread the 2” long nipple (B) into the crossbar (A) until there is
approximately 1 ½” protruding out of the crossbar (A) and
secure with thick lock nut (D). Thread thin lock nut (C) onto the
nipple (B) until snug to the back of crossbar (A) (Figure 1).
3. Using two machine screws (not provided) attach crossbar (A) to the
electric box. Note: A new electric box comes with screws. When
replacing a fixture, retain the screws for use with the new fixture.
4. Run wires through nipple (B) and using suitable wire connectors (not
provided), connect the fixture wires to the supply wires, (white to
white, black to black, bare copper or green to bare copper or green).
Ground the crossbar using the green ground screw (E) to secure a
pigtail lead to the bracket. If the fixture is wired with twin lead lamp
cord, connect the ribbed side to white, and the smooth side to black.
Caution: Make sure wire connectors are twisted on securely and no
bare wires are exposed.
5. Loosen set screw (G) installed into fixture (F).
6. Slip fixture (F) on nipple (B) until firm against wall.
7. Making sure fixture (F) is straight and level; tighten set screw (G) using
supplied wrench until snug.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)
(Figure 3)