Hubbardton Forge 19443600 - Manual (Page 2)

Assembly & Installation Instructions
A128
For Presidio Tryne Chandelier 19-443600 Page 2 of 3 _
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 20378
2. Place canopy (G) over hanger plate (D) and gently lower it so that it rests against canopy cover (B) and body of
fixture.
3. Push hanger plate (D) at top of fixture up into electrical box, past the crossbar. Turn the hanger plate and drop the
threaded studs in the hanger plate into the larger inner holes in the crossbar. Make sure no wires are pinched.
4. Using suitable wire connectors (not provided), connect fixture wires to supply wires (white or ribbed side of
fixture cord to white supply, black or smooth side of fixture cord to black supply, and bare copper to bare copper
or green supply). Push wires back into outlet box. Caution: Make sure wire connectors are twisted on securely, and
no bare wire is exposed.
5. Insert three support rods (I) down through outer holes in canopy (G) (Figure 3) .
See Figure 4 for steps 6 thru 8
6. Slide canopy (G) up over the threaded studs in hanger plate (D) and against ceiling. Secure using two 1/4-20
nuts (H).
7. Start threaded studs (J) into threaded holes in crossbar.
8. Slide canopy cover (B) up over the threaded studs (J) and against the canopy. Secure with the two knurled
balls (K).
(Figure 3)
(Figure 2)
(Figure 4)
(continued)