Hubbardton Forge 19415612HG - Manual

Assembly & Installation Instructions
A238
For Ribbon Chandelier 19-415612HG Page 1 of 3 _
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24409
Install the Canopy (Figure 1)
Component Parts
A Crossbar
B Threaded
Nipple
C Lag Screw (2)
D Lock
Nut
E Canopy
F Loop
Collar
G Threaded Loop
H Chain
I Fixture Loop
J Ground Screw
K Cupped Washer
L Hex Nut
Caution: Be sure power is off at the main breaker box prior to installation.
Caution: This fixture must be supported independently of an outlet
box. Crossbar is designed to fit in the bottom of a standard metal 4”
octagonal outlet box.
1. Drill two holes through the back of the outlet box and using
two lag screws (C) attach cross bar (A) to a structural
member in the ceiling, centering the crossbar in the outlet
box. We've supplied lag screws with your fixture; however,
different materials and/or construction methods may require
different fasteners. If in doubt, contact a qualified
electrician.
2. Thread the nipple (B) into the crossbar (A).
3. Thread lock nut (D) and threaded loop (G) onto nipple, then
place canopy (E) over threaded loop and adjust nipple
length to ensure a snug canopy fit. Once the length is
determined, set the canopy aside and lock nipple position
by tightening the locknut (D) against the crossbar (A).
4. Attach one end of the chain (H) to the fixture loop (I).
5. Attach the other end of the chain to the threaded loop (G)
and thread the fixture wires through every other link of the
chain (H) and up through the threaded loop (G) and nipple
(B) into the outlet box.
6. Using suitable wire connectors (not provided), connect
fixture wires to supply wires (white or ribbed side of fixture
cord to white supply, black or smooth side of fixture cord to
black supply, and bare copper to bare copper or green
supply). Ground the crossbar (A) using the ground screw
(J), cupped washer (K) and hex nut (L) to secure a pigtail
lead to the crossbar. Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
7. Slide the canopy up the chain and over the threaded loop (G), securing
with loop collar (F). Make sure no wires are pinched between the canopy
(E) and the ceiling or crossbar (A).
(continued)
(Figure 1)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.