Hubbardton Forge 19124810SG - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
32320
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Install the Canopy (Figure 1)
Component Parts
A Crossbar
B Threaded Nipple
C Lag Screw (2)
D Lock Nut
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
CAUTION: THIS FIXTURE MUST BE SUPPORTED INDEPENDENTLY OF
AN OUTLET BOX. CROSSBAR IS DESIGNED TO FIT IN THE BOTTOM
OF A STANDARD METAL 4” OCTAGONAL OUTLET BOX.
1. Drill two holes through the back of the outlet box and us-
ing two lag screws (C) attach cross bar (A) to a structural
member in the ceiling, centering the crossbar in the outlet
box. We've supplied lag screws with your fixture; however,
different materials and/or construction methods may require
different fasteners. If in doubt, contact a qualified electrician.
2. Thread the nipple (B) into the crossbar (A).
3. Thread lock nut (D) and threaded loop (G) onto nipple, then
place canopy (E) over threaded loop and adjust nipple
length to ensure a snug canopy fit. Once the length is de-
termined, set the canopy aside and lock nipple position by
tightening the locknut (D) against the crossbar (A).
4. Attach one end of the chain (H) to the fixture loop (I).
5. Attach the other end of the chain to the threaded loop (G)
and thread the fixture wires through every other link of the
chain (H) and up through the threaded loop (G) and nipple
(B) into the outlet box.
6. Using suitable wire connectors (not provided), connect
fixture wires to supply wires (white or ribbed side of fixture
cord to white supply, black or smooth side of fixture cord
to black supply, and bare copper to bare copper or green
supply). Ground the crossbar (A) using the ground screw (J),
cupped washer (K) and hex nut (L) to secure a pigtail lead to
the crossbar. Push wires back into outlet box.
A382
For Aegis Chandelier 19124810SG Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Continued)
A
D
C
E
G
(Figure 1)
E Canopy
F Loop Collar
G Threaded Loop
H Chain
F
B
I Fixture Loop
J Ground Screw
K Cupped Washer
L Hex Nut
H
I
J
K
L