Hubbardton Forge 204795 - Manual (Page 2)

Installation Instructions
B261
Dune Sconce 20-4795 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27144 Rev A
2. Thread the wires in the
electrical box through the
center hole in the wall
mount bracket while
moving the bracket into
position. Attach wall
mount bracket to electrical
box using two machine
screws( not provided)
Using the #8 screws (D),
screw the bracket securely
to the wall. Be careful not
to over-tighten or strip the
anchors.
3. Hold the fixture body (B)
close to the wall mount
bracket (C) and using
suitable wire connectors
(not provided), connect
fixture wires to supply
wires (white to white or
ribbed and black to black
or smooth). Ground the mounting bracket using the green ground screw (G) and cupped washer (H) to secure a
pigtail lead to the bracket and connect all ground wires (bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
4. Carefully tuck all wires behind the fixture assembly and inside the wall mount bracket and place the fixture (B)
firmly onto bracket (C) and fasten with #8 pan head screw w/lock washer (L) (Figure 3).
To Install Glass & Decorative Front (Figures 4 & 5)
Component Parts
A Decorative Front
I Bulb (Included)
J Glass
K Thumb Screw (2)
1. Slide glass tube (J) into decorative front (A).
Secure glass to decorative front using thumb
screws (K) (Figure 4). Set aside.
2. Install bulbs (I). Be careful not to touch bulb
with bare hands; oil from the hands will
dramatically reduce bulb life.
3. Slide decorative front and glass (A & J) over
bulbs and socket (B).
4. Secure decorative front (A) to fixture body (B)
using #8 black screws (D).
5. Restore electricity at main breaker.
(continued)
(Figure 4)
(Figure 3)